Oklahoma Ram Club - View Single Post - Added a trailer break controller to the Mega.

MegaCabMan · 02-01-2013, 06:26 PM

Then remove the cubby hole panel. Note missing screws are the ones to take out.
ImageUploadedByTapatalk1359756801.020350.jpg
ImageUploadedByTapatalk1359756815.070444.jpg

Then put the controller in the cubby hole spot and secure using the screws you just removed and one extra.
ImageUploadedByTapatalk1359756935.621125.jpg

Plug in the two plugs taped to the wiring harness right by the e-break.
ImageUploadedByTapatalk1359757232.353757.jpg

Now put all of the panels back on.
ImageUploadedByTapatalk1359757311.789752.jpg

When you get the kit from the dealer it should have 2 bezels (1 black & 1 tan), the controller, 2 Phillips screws, 1 torx screw and a very good set of instructions.

You don't have to use my write-up to do this. Really the only reason I posted this is to show how easy it was to do.

All that is left for me to do now is have the computer updated with the new part information so the control shows up in my EVIC. As understand this is purely optional and the controller is fully functional without the update.

02-01-2013, 06:26 PM	#2
MegaCabMan King of Fun Join Date: Aug 2011 Posts: 213	Added a trailer break controller to the Mega. Then remove the cubby hole panel. Note missing screws are the ones to take out. ImageUploadedByTapatalk1359756801.020350.jpg ImageUploadedByTapatalk1359756815.070444.jpg Then put the controller in the cubby hole spot and secure using the screws you just removed and one extra. ImageUploadedByTapatalk1359756935.621125.jpg Plug in the two plugs taped to the wiring harness right by the e-break. ImageUploadedByTapatalk1359757232.353757.jpg Now put all of the panels back on. ImageUploadedByTapatalk1359757311.789752.jpg When you get the kit from the dealer it should have 2 bezels (1 black & 1 tan), the controller, 2 Phillips screws, 1 torx screw and a very good set of instructions. You don't have to use my write-up to do this. Really the only reason I posted this is to show how easy it was to do. All that is left for me to do now is have the computer updated with the new part information so the control shows up in my EVIC. As understand this is purely optional and the controller is fully functional without the update. __________________ I am the King of Fun! Just ask anyone. Everywhere I go, people always say, "Here comes that Fun King Randall."