Okla Rams

**myoung84** · 01-09-2013, 07:07 PM

You could make it work!

Matt · 01-09-2013, 08:07 PM

Originally Posted by myoung84

What's the overall width of your 40"? I'd probably have to do some trimming on the plastic but I don't mind that. Only problem with putting it there is it wouldn't be protected at all and it could be very vulnerable to damage offroad.

i will check as soon as i can find my tape measure

Originally Posted by myoung84

I'm a little concerned with putting small ones behind the grille, I think my inserts would block a lot of light. The slats are about a 1/2" wide with a 1/2" space in between. I think I would have to go with a single row light for those.

i think you would be surprised ... but non obstructed would be best for sure i think the 40 at the bottom would be nice

Originally Posted by BMRbrnSNRbrd

Is it bad I want one, even though it doesnt work for my trucks look?

i was thinking about this earlier for a different truck ... wonder if you put a light layer of tint or that lamix or whatever stuff if it would just blend in behind your grille and be stealth .. think that would be awesome ..

BMRbrnSNRbrd · 01-09-2013, 08:08 PM

Thats exactly what I was thinking!

(S.M.R) 101 · 01-09-2013, 09:08 PM

You could rock it for sure Dave.

Morgan I did think about putting it in the lower part of the grill but I was also thinking about clearance issues... and with the light bar being that low, would you still get a good output with it being so low?

Matt · 01-09-2013, 09:30 PM

i played around with mine and yes while higher works better you can still get good output lower .. just have to angle it a bit different obviously ...

916Timmy · 01-09-2013, 10:32 PM

When I was 10 or so....I totally wanted a lowered dually crewcab chevy with the offroad hoop light bars in the bed!

**myoung84** · 01-10-2013, 03:27 PM

Got some scrap wood and made a rough representation of what a 40" light bar would look like. Then did some photoshopping. I don't think I like it and it might be too low for decent light output. It would take some major trimming on the plastic lower bumper to make this work.

Matt · 01-10-2013, 04:03 PM

Yeah I don't like that either I would figure a way to somehow mount it to that bar securely

(S.M.R) 101 · 01-10-2013, 04:22 PM

yeah, just needs to be higher.

**myoung84** · 01-10-2013, 04:25 PM

That would put me into a 30" bar. I sort of want to ditch the light bar mount all together but I'm not sure. So confused right now.

Something like this would be cool. These are 12" VisionX lights.

http://www.visionxusa.com/LED-Xmitte...duct_info.html