New truck thread

[0212353]

looks good to me!

[myoung84]

Anthracite plastidip is done! It's a damn close match to the Graphite paint...

[0212353]

not bad!

Guess what.....



Mini H1 v7!! (prototypes here) - but yeah, much better performance than the matchboxes I was shoving in these '13+ foggies.....just need to nail a few more pairs here! LOL

[myoung84]

That combo would be perfect!

[0212353]

Originally Posted by myoung84 That combo would be perfect!

[(S.M.R) 101]

Originally Posted by myoung84 Anthracite plastidip is done! It's a damn close match to the Graphite paint...

Morgan, Damn.... That looks awesome man.

[(S.M.R) 101]

Originally Posted by 0212353 not bad! Guess what..... Mini H1 v7!! (prototypes here) - but yeah, much better performance than the matchboxes I was shoving in these '13+ foggies.....just need to nail a few more pairs here! LOL

Looks legit Jeremy!

[Okiespaniels]

Nice job on the rims!

[myoung84]

Had my second set of Bora wheel spacers come in this week. (Full story HERE). Installed them in just a few minutes and they fit perfect. Very happy with them and the truck looks a lot better with the wheels pushed out. I hated the look of them tucked in so far. The stock wheels have a +19.05mm offset and with the 1.25" spacer, they are now -12.7mm. I think a 1" spacer up front might have been a little better, but I still like the look. The rear is flush with the flares and the front sticks out a hair. I'm pretty sure I'd have to cut the studs with a smaller spacer though.

One word of caution if you don't cut your studs flush with the spacer, your spare is not going to bolt up. Two options are to cut all the studs flush (not something I want to do) or carry a breaker bar and 13/16" socket to remove the spacer lug nuts in the event you need to use the spare. That's what I plan on doing. I'll also carry a 7/8" socket to remove the wheel lug nuts as my 18" breaker bar is easier than the OEM lug wrench.

[0212353]

looks great!