Added a trailer break controller to the Mega.

[MegaCabMan]

It took 22 min and $234.00.
ImageUploadedByTapatalk1359756471.569772.jpg

First remove the side panel
ImageUploadedByTapatalk1359756507.470315.jpg

Then the panel under the steering column.
ImageUploadedByTapatalk1359756559.070342.jpgImageUploadedByTapatalk1359756577.386924.jpg

[MegaCabMan]

Then remove the cubby hole panel. Note missing screws are the ones to take out.
ImageUploadedByTapatalk1359756801.020350.jpg
ImageUploadedByTapatalk1359756815.070444.jpg

Then put the controller in the cubby hole spot and secure using the screws you just removed and one extra.
ImageUploadedByTapatalk1359756935.621125.jpg

Plug in the two plugs taped to the wiring harness right by the e-break.
ImageUploadedByTapatalk1359757232.353757.jpg

Now put all of the panels back on.
ImageUploadedByTapatalk1359757311.789752.jpg

When you get the kit from the dealer it should have 2 bezels (1 black & 1 tan), the controller, 2 Phillips screws, 1 torx screw and a very good set of instructions.

You don't have to use my write-up to do this. Really the only reason I posted this is to show how easy it was to do.

All that is left for me to do now is have the computer updated with the new part information so the control shows up in my EVIC. As understand this is purely optional and the controller is fully functional without the update.

[Matt]

your pictures aren't loading for me

[BMRbrnSNRbrd]

I see them now.