I fabbed up a bracket for the switch out of a strip of aluminum I had laying around. For power, I tapped into the 12V wire at the trailer plug and ran straight to the switch, then ran a single power wire to the passenger side light. Didn't use a relay since these draw almost no power at all. I grounded each side separately with a small self tapping screw hidden behind the bed rug. I used 14 gauge wire for everything, which is extreme overkill, but I had a couple of spools of it already. Something in the 18-22 gauge would be better. For light adhesion, I used some Loctite double sided tape that claims 100 lbs of holding power per roll and is good in the heat. This stuff is super sticky and the lights should never fall. They are brighter than I thought they would be and really light up the bed at night. They will come in handy when trying to tie down my ATV at night.
Here are some pics, I'll try to get a better night time pic this evening.
__________________
2014 Ram 1500 4x4 Outdoorsman
Retro Shop Custom FXR Projectors | Diablo inTune | Moe's 87mm TB | BT Oil Catch Can
Toyo A/T II Tires | Bilstein 5100 Front & Rear Shocks | AirLift 100 Air Bags
Bestop PowerBoards | RollBak Bed Cover | BedRug