You have to cut the runners down about an inch or 1.25 inches(?) for a 318, then it is recommended you "knife edge" the inlets and ball grind the injector ports where they enter the intake for a better pattern.
There are lots of threads on this in other forums. I would suggest googling "kegger mod" and see what you get.
BTW the information on RF is partially erroneous...filling the kegger with epoxy decreases the overall volume of the area and increases velocity in the low end not the top end. If anything too much filler restricts flow and thus top end power.
Last edited by Okiespaniels; 03-05-2012 at 08:24 PM.
|