Oklahoma Ram Club - View Single Post

Okiespaniels · 10-06-2011, 09:28 PM

Ok..but it was run along the intake manifold/valve cover right? I could see where too much slack might have it end up in the exhaust. There's supposed to be a clip that presses on your lower corner valve cover bolt to keep that from happening.

10-06-2011, 09:28 PM	#8
Okiespaniels Coffee, Gas, Ammo. Set! Join Date: Aug 2011 Location: Work, Garage, Computer room Posts: 685	Ok..but it was run along the intake manifold/valve cover right? I could see where too much slack might have it end up in the exhaust. There's supposed to be a clip that presses on your lower corner valve cover bolt to keep that from happening.