Oklahoma Ram Club - View Single Post

swirvin21 · 04-23-2012, 11:35 AM

Bunch of 1 ton axles
Trying to clean out the shop. Shannon came by and looked at the D80 3.54 rear end, was going to do the swap but brakes were slightly different. I'm always open for trades, especially

but make offers on anything

AXLES:
FRONTS:

-Dana 60 HP SRW, 4.10 gears, open (not sure), this is just the housing no knuckles out. Out of a 95 Ford F350, Ball joint axle. Setup for leafs: $400

-Dana 60 HP DRW, 4.88 gears, open, disc brakes, complete axle. This has extra large 3.5" tubes from a 2004 Ford F450, Ball joint axle. Setup for leafs. Pattern is 8 on 225mm, but it is adapters on the Ford 8 on 170mm pattern: $800

I will be pulling the 3.54 Dana 60 out of my '98 Ram once I find a 4.10 unit to swap in. It will be for sale as well, complete: $600

REARS
Both out of 98-99 Dodge Ram 2500 V10 trucks (both 8 on 6.5" pattern)
-Dana 80 SRW rear, 3.54 gears SOLD
-Dana 70 SRW rear, 3.54 gears, open diff (think), drum brakes, complete in driving truck $500
-Dana 80 DRW rear, 3.54 gear (bad), open carrier, disc brakes. Gears were chipped and damaged, needs rebuild, but all parts are included (drum in hat parking brake w/ disc): $500

Out of 2004 Ford F-450 DRW
-Dana S135 DRW rear SOLD

RAM STUFF:
-NP241DLD transfer case, 23 spline input SOLD
-rear sway bar from a D80 rear: $50
-5.9L V8 360 throttle body complete w/ sensors: $50
-spare 3/4 ton 4x4 steering box: $50
-V10 front coil springs, stock height(2-3" lift for 1500s): SOLD
-pair of spare shock towers: $30
-rear 2 piece driveshaft from long bed quad cab 2000 auto 4x4 V10 truck: $100
-would consider selling a complete V10/47RE conversion w/ motor, trans, wiring harness and computer for $1500
-passenger side airbag from 2000 ram (no cover): $50
-3/4 ton rear lift block 5": $30

I probably have a few other things sitting around, but no interior parts other than listed. I know a good Dodge junkyard nearby, good guy for an owner, so might be able to help some.

Also have a NP208 from a Chevy Blazer for $50

Also have some Ford F450 parts from a chassis I picked up, see photos

Kyle
(918)729-2239

Everything is around Tulsa: Kiefer or Haskell.

F450 stuff

04-23-2012, 11:35 AM	#1
swirvin21 V6 Member Join Date: Apr 2012 Location: Glenpool Age: 44 Posts: 175	Bunch of axles & Ram parts!! Bunch of 1 ton axles Trying to clean out the shop. Shannon came by and looked at the D80 3.54 rear end, was going to do the swap but brakes were slightly different. I'm always open for trades, especially but make offers on anything AXLES: FRONTS: -Dana 60 HP SRW, 4.10 gears, open (not sure), this is just the housing no knuckles out. Out of a 95 Ford F350, Ball joint axle. Setup for leafs: $400 -Dana 60 HP DRW, 4.88 gears, open, disc brakes, complete axle. This has extra large 3.5" tubes from a 2004 Ford F450, Ball joint axle. Setup for leafs. Pattern is 8 on 225mm, but it is adapters on the Ford 8 on 170mm pattern: $800 I will be pulling the 3.54 Dana 60 out of my '98 Ram once I find a 4.10 unit to swap in. It will be for sale as well, complete: $600 REARS Both out of 98-99 Dodge Ram 2500 V10 trucks (both 8 on 6.5" pattern) -Dana 80 SRW rear, 3.54 gears SOLD -Dana 70 SRW rear, 3.54 gears, open diff (think), drum brakes, complete in driving truck $500 -Dana 80 DRW rear, 3.54 gear (bad), open carrier, disc brakes. Gears were chipped and damaged, needs rebuild, but all parts are included (drum in hat parking brake w/ disc): $500 Out of 2004 Ford F-450 DRW -Dana S135 DRW rear SOLD RAM STUFF: -NP241DLD transfer case, 23 spline input SOLD -rear sway bar from a D80 rear: $50 -5.9L V8 360 throttle body complete w/ sensors: $50 -spare 3/4 ton 4x4 steering box: $50 -V10 front coil springs, stock height(2-3" lift for 1500s): SOLD -pair of spare shock towers: $30 -rear 2 piece driveshaft from long bed quad cab 2000 auto 4x4 V10 truck: $100 -would consider selling a complete V10/47RE conversion w/ motor, trans, wiring harness and computer for $1500 -passenger side airbag from 2000 ram (no cover): $50 -3/4 ton rear lift block 5": $30 I probably have a few other things sitting around, but no interior parts other than listed. I know a good Dodge junkyard nearby, good guy for an owner, so might be able to help some. Also have a NP208 from a Chevy Blazer for $50 Also have some Ford F450 parts from a chassis I picked up, see photos Kyle (918)729-2239 Everything is around Tulsa: Kiefer or Haskell. F450 stuff __________________ Kyle USMC 2003-2009 "The only thing necessary for the triumph of evil is for good men to do nothing." Last edited by swirvin21; 07-23-2012 at 12:56 PM.