Originally Posted by 916Timmy
Clear silicone!
|
don't do that.....
Clear is ok at the end (as a seal over a seal), but using it to seal up the light isn't a good idea. I wish I learned this earlier than my first couple months of doing lights. Clear silicone gases like a mofo.
Originally Posted by ramthis9501
Oh and what should I use when I glue it back together?
|
Butyl rubber (windshield weld, etc)
Originally Posted by BMRbrnSNRbrd
Honestly dude I would skip the hassle and order new ones...if they leaked when practically brand new, they are probably made of cheap, brittle plastic that will end up breaking and leaving you without a headlight.
Contact Jeremy and see what his TYC price is for some new 2nd gen headlights, he's now a dealer and gets special pricing.
|
2nd gen lights are F'N $$. TYC sells the sport ones, 120 a pop.
My advice? Don't open them. Thats not going to get you anywhere. You'll probably try to wipe the inside lens clean, which WILL scratch the f out of the lens. Leave it sealed, put silicone around the bulbs. Dunk it in a water tank and check for bubbles.
