Checked out the fuel door this morning on the way out for work and it looks pretty good. I did a few light coats of clear and then a few very heavy (just short of running) coats so that I have plenty to wetsand without damaging the overall finish.
I do have some orange peel, but I'm pretty sure I can wetsand that out without a problem. The clear didn't lay down as well as I normally can..but then again I dropped the can at one point which popped the actual nozzle off and sent it flying across the garage...then I realized a small piece actually broke off and was stuck in the can so I couldn't just pop the nozzle back in. It still worked but it created a small geyser of clear from the bottom of the nozzle every time I sprayed so I'm not surprised the clear didn't come out as well as normal.
I'm going to check it out some more this evening when I get home and see if it needs a couple more coats to insure I don't sand through while wetsanding.
Last edited by BMRbrnSNRbrd; 09-14-2011 at 08:53 AM.
|