Thought I'd share my other project while I was at it. Might give you guys more of an idea why the Ram project seems to be moving slow.
Finally had a nice enough day to pull the Jeep out of the garage and actually CLEAN her! I shoveled...yes, shoveled out at least 30 lbs of dirt, rock, sand, pieces of wood and random pieces. I hosed out the frame rails and the fuel tank skid for probably 1/2 the time alone. But it's done now and she looks great! I went ahead and cleaned up a few spots where there was a little surface rust and one almost bad spot in the passenger floor pan, but everywhere else is pretty clean.
I've finally figured out most of the plan on body upgrades:
-Poison Spyder TJ DeFender™ XC (High-Line) - 3" Tapered Flares (Steel)
http://shop.poisonspyder.com/TJ-DeFe.../14-02-093.htm
-TNT HyLine "Zyros" for TJ
http://www.tntcustoms.com/jeep_wrang...ner_armor.aspx
-TJ Boatsides from THE ONE FABRICATION
http://www.pirate4x4.com/forum/body-...ocker-kit.html
Haven't decided 100% on the rear fuel tank. Considering the Genright, but also found this PureJeep extended stretch tank that is a little cheaper:
http://shop.savvyoffroad.com/product...1&categoryId=4
The next thing would be a good cage. There are a ton of options here, but I'm very interested in these TMR Cage Pillars as they lower the windshield cross bar farther than the others I've looked at.
http://www.tmrcustoms.com/store/inde...roducts_id=489
That's pretty much where I stand right now. A few other small things like rear coil locating buckets from either Genright or Rokmen are on my list as well. That's pretty much it for now. Small steps, but big plans as usual....