I'll just have the upper center console and two side vents. I'm kind of liking these:

http://i1089.photobucket.com/albums/...ps18e6e743.jpghttp://i1089.photobucket.com/albums/...ps41c5b15f.jpg

yeah, that should knock off about $75 of it. (estimated!)

I saw those patterns too, I like those - something simple to set it off. That machined look is pretty sweeeeet

I might be down for the brushed aluminum...

Cool. Keep an eye on RF in my section, I'll have it up in the next few weeks - and I'll let ya know.

Something spiffy! I went out to find another painter to releave some stress from the main one (we are booked into May!) and found not only a painter, but a dipper too. ;)

Dip the headlights with some crazy MG and PS2 Silver? :D

might be tough on the heads....

lots of deep pockets and such. But, after I get used to how the guy works, I can see how it will roll. :D

Honestly, on a two tone setup, I'd just say stick to paint. Unless you wanted some weird setup with reaper skulls and silver? LOL

Reaper skulls on the bezels and shrouds would be sweet on your truck Kyle!

Eh, not my style... altough would be pretty sick :D

This stuff is awesome! A place here in sapulpa does it too, primarily to gun stocks etc.. Is there any chance your guy has a blaze orange camo pattern? I've been looking for a place that does those dips and has a blaze orange camo to have my bow redone

he can pretty much get anything, and there are SO many to list.

Best bet, take a look at watertransferprinting.com - they have a HUGE selection, I know he can get all of those. Or if you find any (elsewhere), shoot it over to me and I can check with him. ;)